Vertical Pumps

Vertical Pumps
  • jolly

  • Jolly Series

    • Designed for heavy duty slurry and/or acid applications.

    • The JOLLY Series pumps are custom built to customer specifications.

    • The shaft is always supported above the baseplate by two bearings inside the base.

    • The pump-motor coupling is an elastic joint or V-belt.

    • The maximum length of the pump under the base can reach 4-5 meters (13-16 ft).

    • Using a sleeve bushing as the sealing system, the JOLLY Series pumps cannot run dry under a certain level.

    • Capacities from 5 to 1500 m3/h (22 to 6,613 gpm).

    • Maximum discharge pressure from 6 to 7 bar (88 to 103 psi).

  • Mec Series

    • Designed for heavy duty slurry and/or acid applications.

    • The MEC Series only has direct transmission by means of an elastic joint. There is always a metallic structure around the motor with a lifting eyebolt at the top.

    • Lengths under the bases are standard and do not exceed 2 meters (7 ft).

    • Using a sleeve bushing as the sealing system, the MEC Series pumps cannot run dry under a certain level.

    • Capacities from 5 to 1500 m3/h (22 to 6,613 gpm).

    • Maximum available pressure from 6 to 7 bar (88 to 103 psi).

  • serie_mec

  • aus

  • Aus Series

    • Designed for heavy duty slurry and/or acid applications.

    • The AUS Series pumps can run dry since there is no mechanical seal.

    • Mechanically speaking these pumps are the same as the JOLLY series, but the maximum length of the AUS Series pump under the base seldom exceeds 2 meters (7 ft).

    • Usually the fluid inlet is above the casing but in some versions it is also near the bottom (double sided impellers).

    • The AUS Series pumps can be installed inside or outside tanks.

    • Capacities from 5 to 1500 m3/h (22 to 6,613 gpm).

    • Maximum available pressure from 6 to 7 bar (88 to 103 psi).

Contact Us

Your Name (required)

Your Email (required)

Firm name (required)

Phone number

Address (country required)

Subject

Your Message